Unable to change config after upgrade.

Here you can submit your bug reports.
Post Reply
Andreas WP
Posts: 6
Joined: Tue Oct 22, 2013 12:57 pm

Unable to change config after upgrade.

Post by Andreas WP »

Hello.
I have tried to uppgrade wftpserver from 4.4.1 to 4.5.6 Linux 64 bit on Ubuntu 14.04.1.
Everything runs ok, version and licens looks ok too. But I can not change any config from webb GUI. No system settings, not add users or group, not change password or IP-filters. When i click ok it looks normal but when i go back into config the last change is gone.
I got no messages about it in any log or in GUI. I have tried on both our servers with same result.
When i go back in revision to 4.4.1 it works ok again.
Is there any known bug or any new library needed? I am stucked.

/Andreas
FTP
Site Admin
Posts: 2072
Joined: Tue Sep 29, 2009 6:09 am

Re: Unable to change config after upgrade.

Post by FTP »

No, there is no such issue in the latest version 4.5.6, you can test it again.
Andreas WP
Posts: 6
Joined: Tue Oct 22, 2013 12:57 pm

Re: Unable to change config after upgrade.

Post by Andreas WP »

OK.
I have tried several times now.
Even fresh install (no upgrade).
I guess i have to go for 4.4.1 and wait for next revision then...

/Andreas
FTP
Site Admin
Posts: 2072
Joined: Tue Sep 29, 2009 6:09 am

Re: Unable to change config after upgrade.

Post by FTP »

OK, I think such issue was caused by the Linux system mostly, because some Linux will not release the port quickly after stopping the WingFTP service, so you just need to wait for a few minutes, and BTW, the new version 4.5.8 is out now, you can upgrade to it first.
Post Reply